KD3202T - Matrix Video Transmitter

HD Video Transmitter over 100Mbps Network, HDMI Loop Output, RS232 Control, Analog Audio Embedding, USB/KVM

HD Video over IP Transmitter suited for distribution of Audio, Video, IR and USB over a standard L2 network.

The KD3202T is part of the AV/IP range of video distribution products from KLIK, employing a proprietary SoC that enables full 1080p@60 video transmission up to 100m over standard network architecture, or 180m over a single Cat5 cable. The transmitter employs H.265 technology and supports HDMI, IR, Audio, and USB distribution, making it ideal for both commercial and residential applications.

Key Features

• High-Definition Video, Audio, Control, & USB over TCP/IP Networks
• Extend HDMI signal up to 180m (600 ft.) over single Cat5 cable (without switch)
• Use conventional L2 Ethernet switch for extension & distribution to 100m or cascade switches for extended distances
• Supports up to 4096x2160@30Hz, 3840x2160@30Hz, and 1920x1080@60Hz
• Supports EDID & Transmitter Resolution pass-through, including 16:9, 16:10, 4:3 resolution & timing
• Switchable Graphics/Video mode with ultra-low latency of 60-100ms
• Selectable Multicast mode for Matrix Routing or Unicast for point-to-point extender
• Supports USB signaling (Keyboard, Mouse, Touch Display) for KVM applications
• Supports Analog Stereo Audio over IP, independent of HDMI audio channel
• Supports IR Control (20KHz-60KHz) extension over IP
• Features HDMI 2.0a x 1 (Type A) Video/Audio Input & HDMI 2.0a x 1 Loop Output
• Fully Compliant with HDMI 1.4 and HDCP 1.4
• Built-in ESD Protection system
• Firmware updates available OTA

Specifications

• Video Input: 1 x HDMI Type A, 19-pin, female
• Video Output: 1 x LAN RJ45 connector, 1x HDMI Type A, 19-pin, female
• Latency: 60ms Graphics Mode, 100ms Video Mode, No Latency on HDMI Loop Output
• Audio Input: 1 x 3.5mm Stereo (TRS) Jack
• Ethernet Port: 1 x LAN RJ45, 10/100Mbits
• RS-232 Serial Port: 1 x 3-Pin Phoenix Connector, RS-232 Protocol, Device Control
• USB/KVM Host Port: 1 x USB-Type A
• IR Output: 1 x 3.5mm Mono (TS) Jack
• Dimensions (W x D x H): 172mm (6.77”) x 55.85mm (2.20”) x 27mm (1.06”)
• Operating Temperature: 32°F to 104°F (0°C to 40°C)
• Storage Temperature: -4°F to 140°F (-20°C to 60°C)
• Warranty: 3-Year Standard Warranty, 5-Year Project Registration Warranty

Carton Contents

• 1 x KD3202T
• 1 x 12VDC/1A Power Supply

All specifications are preliminary and subject to change. That said, they won't change much, but if in doubt go ahead and reach out to support@klikboks.com with your specific requirements and we'll do our best to accommodate.